Kit nạp phần mềm AVR JTAG ICE

Thương hiệu:  |  Tình trạng: Còn hàng
Kit nạp phần mềm AVR JTAG ICE

Kit nạp phần mềm AVR JTAG ICE 


Value stabilization AVR-USB emulator features:

1 The latest version of the design, add a buffer chip (to prevent the improper operation of the punch firmware);

2 plus a 0.5A PTC FUSE (to prevent short circuit burned out the computer motherboard);

3 Wide operating voltage, support 3.3V;

4 This emulator firmware upgrade can be unlimited, both upward and downward compatibility, support for AVR STUDIO software up to date 4.12/4.14/4.16/4.17/4.18!!!!


JTAG Introduction

AVR JTAG with Atmel's AVR Studio + iccavr or WINAVR based on a complete set of compatible JTAG interface chip debugging tool supports all AVR 8-bit RISC instruction with JTAG port of the microprocessor. JTAG interface is a 4-wire IEEE 1149.1 compliant Test Access Port (TAP) controller. IEEE standards provide an effective test circuit board connection standard methods (boundary scan). Atmel's AVR devices has been extended to support full programming and on-chip debug function.

AVR JTAG emulator used for chip hardware emulation, such as single-step program execution, set breakpoints, etc., through hardware emulation can understand the details of the chip inside the program operation. AVR JTAG emulator is mainly used to simulate operation of the chip, but also can be programmed through the JTAG interface chip (the program into the chip).

  Supported chip

ATmega128, ATmega128L, ATmega16, ATmega162, ATmega162V, ATmega165, ATmega165V, ATmega169, ATmega169V, ATmega16L, ATmega32, ATmega323, ATmega323L, ATmega32L, ATmega64, ATmega64L (supports all AVR microcontrollers with JTAG port).

The emulator connected to a USB port, the other one received a standard ten-pin JTAG interface, compatibility superior performance than similar products, PC software is AVRstudio, compatible 4.12/4.13/4.17/4.18 and later, the firmware can be upgraded;



Các nội dung Hướng dẫn mua hàng viết ở đây

Số lượng:

Tổng tiền: